| Subtotal | $0.00 |
|---|---|
| Total | $0.00 |
This instruction show you guide on how to use Ford IDS software to do PCM reprogramming for Ford Focus after PCM replacement.
Preparations:
https://vsst247.com/bmw-retrofits
https://vsst247.com/bmw-remote-programming-coding
Procedures:
Connect your Ford diagnostic tool (VCM2) to car obd port,then run software
Select “Start New Session”–>” All other”
Then wait establishing communication to PCM
It will show you the vehicle information as below,click “Yes” to continue
Input odometer value,then click “OK” icon at lower right corner
Select “Module Programming”
Select “Programmable Module Installation”–>”PCM”
Wait for the process..
Set ignition switch to OFF
Install a new module in vehicle
Click “OK” icon
Please read the follow information carefully:
Note:Do not start a reprogramming session with a low battery in the vehicle and/or programming tool.
The fuel pump and the engine cooling fan(s) may run during the following procedure
If you are programming a 6.0L diesel,the FICM relay must be removed before programming.
The Ford IDS will prompt you to set the ignition switch to ON
PCM reprogramming..
Please wait
When PCM reprogramming process done,follow the prompt to set ignition switch to OFF
Then set the ignition switch to ON again
Set ignition switch to OFF
Here are some repeat steps,just follow prompt
Calibration has been loaded and checked
If you programmed a 6.0L diesel please reinstall the FICM relay
If required,obtain a PCM reprogramming label and complete with the following data:
Start engine
Note:Do not depress the throttle pedal
Set ignition switch to OFF
Set ignition switch to ON
Now here clear DTCs
Done!
#programmingfordpatskey #fordretrofit #fordfocusretrofit #fordconnectrollerlifters #fordretrofitelectric #fordfocusretrofitcruisecontrol #bmwretrofitcomfortaccess #bmwretrofitcamera #bmwretrofitcoding #bmwretrofitcruisecontrol #bmwretrofitharmankardon #bmwretrofit360camera #bmwretrofitremoteenginestart
Thank For 
OEM Porsche PIWIS 3: PPN remote programming
Activate Design AMG For Cluster
Software Version Management (SVM) VAG Group
Jaguar Land Rover Coding and Configuration
68 D. No. 60, An Phu, District 2, Ho Chi Minh City 
