Shopping Cart

Subtotal $0.00
Total $0.00

How to Adjust Pump Mechanical Idle Speed for Scania Truck


This instruction show you guide on how to check and adjust mechanical idle speed on the pump for Scania truck.For more information about Scania truck,please refer to:Scania Trouble Repair.


Related Contents:



1.Run the engine until warm, preferably using frequent retarder braking, for at least 30 minutes. The engine must be warm throughout.

2.Undo the latch clamp securing the ball joint (1) at the injection pump. Remove the link rod from the arm.




3.Start the engine.

4.Measure the engine speed against the marking on the pulley. Use an IR tachometer.

Note: Do not use the tachometer on the instrument panel. It does not yield a sufficiently accurate reading.


5.Adjust to the desired speed (520 or 550 rpm) using the idling screw.

  • Undo the lock nut (1) on the under side. Adjust the idling screw (2).
  • Ensure that the arm (3) is resting against the idling screw.
  • Tighten the lock nut (1).

6.Shut off the engine using the starter key.

Next: “Clear the end position memory”.



#AdjustPumpMechanical #IdleSpeed #ScaniaTruck #BmwRemoteProgrammingcode #ServiceBMW

Thank For donatepaypal

BMW Apple Carplay Activation

Price: $100.00 $120.00
Watch Now

BMW Coding and Programming

Price: $50.00 $64.00
Watch Now

BMW Retrofits

Price: $50.00 $64.00
Watch Now


Price: $100.00 $120.00
Watch Now

Related Posts

BMW E Series Secondary Air System Failure Analysis Guide

Cadillac CT6 Shake Slightly When Accelerating Solution

Volvo EC200D Excavator Engine Removal Guide

Audi A5 2014 ECU Online Long Coding by Launch X431 PAD V

DiagProg 4 Correct Odometer & Clear DTCs for Audi A8 S8

Nissan Maxima 2017 Idle Air Volume Learning by Launch X431 Throttle