| Subtotal | $0.00 |
|---|---|
| Total | $0.00 |
This instruction shows you guide on how to do E65 730d Webasto heater configuration by BimCOM. The same procedure applies to other control units as well.
Procedures:
Connect BimCOM to Vehicle, running BimCOM software.
Click “Select Control Unit”
Select correct Model, click “Go”
Click “Chassis”, select “SHZH-Fuel powered external heater”, then “Go”
Select “Configuration”
Select “ Remote-start with Webasto accessories”, click “Edit”
Change “Disabled” to “Enabled”, then continue
Click “Write configuration to ECU”
Click “Yes”
Configuration was successfully written to the ECU. Click “OK”
BMW Diagnostic Software BMW ISTA+ BMW ISTA-D BMW ISTA-P Esys
68 D. No. 60, An Phu, District 2, Ho Chi Minh City 
