| Subtotal | $0.00 |
|---|---|
| Total | $0.00 |
This instruction will show you guide on how to reset service oil and inspection by ODIS for 2017 AUDI Q3.
Procedures:
Connect ODIS to vehicle OBD port, then running software.
Click “Start Diagnosis”
Select correct basic vehicle characteristics, click “Adopt”
Click “Without Job”
Click “Address”
Click “Fault Memory list”
Click “Information Control Unit”
Click “Done/Continue”
Still click “Done/Continue”
Click “Done/Continue”
Click “Special functions”–>”17-Inspection with oil change-10000KM”–>”Perform test”
Click “Yes”
Click “Done/Continue”
Inspection service was successfully, Click “Done/Continue”
Test finished, click “Done/Continue”
Click “Control units”–>”Control unit list”–>”0017 Dash Board “–>”self-diagnosis”
Select “0017-Dash Board”–>”Adaption”
Input “sia” for Filter, then input “180”
Click “Yes”
Click “0017 Dash Board”–>”Diagnosis”–>”Save”–>”OK”
After saving, click “Data”–>“Stop”–>”Without saving”
Function is ready
#ResetServiceOil # InspectionviaODIS #AUDIQ3
Thank For 
Immobilizer Service Remove VAG Group
Lamboghini Service Component Protection, Immobilized , SVM
BENTLEY Service Component Protection, Immobilized , SVM
Software Version Management (SVM) VAG Group
68 D. No. 60, An Phu, District 2, Ho Chi Minh City 
