| Subtotal | $0.00 |
|---|---|
| Total | $0.00 |
After Benz DTS Monaco software installation,you need configure DTS Monaco for interface (here take MB SD C4 DoIP as example).So here car-auto-repair.com show you guide on how to setup connection between DTS Monaco and MB SD C4 DoIP.
Procedures:
After DTS Monaco installation,open network and sharing center
Click “Change adapter setting”
Right lick “Local Area Connection” and select “Properties”
Select “Internet Protocol Version 4 (TCP/IPv4)”—>”Properties”
Select “Use the following IP address”,and set address as below:
IP address:172.29.127.35
Subnet mask:255.255.255.0
Then click “Advanced…”
Click “Add”
Set address as below:
IP address:169.254.0.35
Subnet mask:255.255.0.0
Then click “Add”
Click "OK" and "Close"
Now right click “Wireless Network”,then select “Properties”
Select “Internet Protocol Version 4 (TCP/IPv4)”—>”Properties”
Select “Use the following IP address”,and set address as below show
IP address:192.168.2.35
Subnet mask:255.255.255.0
Then click “OK”
Click “Close”
Now right click “SDconnect Toolkit” at lower right corner to select “Administration”
Click “Register/configure” option
It will show you the information as below.
Check off the “WLAN parameters,workshop” option
Select “Encryption” type to “WEP/Hex”
And set a Key:aaaaaaaaaaaaaaaaaaaaaaaaa
And exit SDconnect Toolkit
Now you can run DTS Monaco with MB SD C4 DoIP.
After then click “Start”
Thank For 
Offline Coding & Programing with DAS
Mercedes Navigation License Code
Mercedes Benz Diagnostic new car 2022+
Mercedes Benz Instrument Cluster Renew
Activate Design AMG For Cluster
68 D. No. 60, An Phu, District 2, Ho Chi Minh City 
