Here comes the gudie on How to use BMW E-sys coding software.After you reading this article,hope you can use E-sys coding software to coding for you BMW.
Step 1: Install BMW E-sys Coding Software on you laptop.
Step 2: Connect cable to computer then to car.
Step 3: Open the E-sys software,and click the connect button.
Step 4: Select F series you are working on, my case F10 and select Connection via VIN and click “Connect”
Step 5: Click “OK”
Step 6: Click “Read”
Note:Option to save or not to save.
Step 7: Click “Read (VCM)”(Read SVT in newer E-Sys versions)
Step 8: Select CADF (only one with a green Check mark) file under the module you want to read
and select “Read Coding Data”
Step 9:Error Report, Click “Close” (or save if necessary)
Step 10:New option under CADF, a folder. Expand the folder by clicking + and right click that file, Select “EDIT FDL”
Step 11: Browse the folders till you find your option, I want option KOMFORTSCHLIESSUNG_FB
Step 12: Factory option set to nicht_active. Right click, select “Edit”
Step 13:Select option desired, in this case, select “aktiv”
Step 14: Once all changes have been made, Click the “Save” icon
Step 15: Once saved, click the green back arrow
Step 16: Right click FA, select “Activate FA”
Activating FA, just wait till it finishes. Once finished, FA should show (active) in green. If not, try again.
Note: If you do not activate FA as described in Step 19, you will receive this message
Step 17: Select the CAFD file that you just edited and then click “CODE FDL”
Step 18 :Coding FDL (progress)
Step 19:After it completes, Click “Close”
Step 20: Error report will open, view and click “Close” (or save if necessary)