Shopping Cart

Subtotal $0.00
Total $0.00

How to Use WinEEM4 Service Tool Perform DPF Regeneration


This instruction show you guide on how to use WinEEM4 service tool software to do DPF regeneration.




WinEEM4 service tool DPF regeneration provides the means to activate the DPF regeneration functionality. The graph in the middle of the page plots the temperatures which are most relevant to DPF regeneration process. Several other relevant values are displayed in the right side of the page.


When test is activated by user, engine speed will be set automatically to ~1500 rpm. Engine Management System then starts controlled DPF regeneration process. The process takes about 30-50 minutes, time may vary due to environmental conditions and DPF soot load level. During DPF regeneration engine noise level may vary. Process progress will be shown to user. After DPF regeneration engine will return to low idle. Let engine cool down on low idle minimum of 2 minutes before shutdown.


#WinEEM4Service #DPFRegeneration #ServiceVAG #FordRetrofit #ServiceFORD
Thank For donatepaypal

Immobilizer Service Remove VAG Group

Price: $50.00 $64.00
Watch Now

Activate Design AMG For Cluster

Price: $100.00 $120.00
Watch Now

Mercedes Retrofit

Watch Now

SDD JLR Software

Price: $100.00 $120.00
Watch Now

Offline Coding & Programing with DAS

Price: $150.00 $180.00
Watch Now

Ford PATS Key Programming

Price: $40.00 $55.00
Watch Now

Related Posts

BMW E Series Secondary Air System Failure Analysis Guide

Cadillac CT6 Shake Slightly When Accelerating Solution

Volvo EC200D Excavator Engine Removal Guide

Audi A5 2014 ECU Online Long Coding by Launch X431 PAD V

DiagProg 4 Correct Odometer & Clear DTCs for Audi A8 S8

Nissan Maxima 2017 Idle Air Volume Learning by Launch X431 Throttle