| Subtotal | $0.00 |
|---|---|
| Total | $0.00 |
If you had issues with your vehicle and turned out that the ECU was defective and needed to be replaced. What you basically did is disconnect the old ECU and connect the replacement ECU. After that, it’s no more than two minutes in the Abrites Diagnostic for Jaguar/Land Rover software. This post will show your guide on how to fix it after replace ECU for 2017 Range Rover Evoque.
Steps:
Disconnecting the original ECU.
Its location is under the front bonnet next to the windshield wiper’s motor.
Connecting the replacement ECU
It needs to be adapted with Module Initialisation.
Connecting the AVDI interface to the OBD port of the car
Connecting AVDI to the laptop and starting the JLR software
Enter the “Vehicle Selection” menu and select the model
Select “Land Rover-2017 Land Rover Evoque/L538-GTDI-2.0 PETROL”
Open the “Special Function” tab
Enter the “Key Learning” menu
Select “Module Initialization” option and press “Execute”
A minimum set of two programmed keys is required. Click “Yes”
Close all vehicle doors, switch the ignition ON. Click “OK”
Make sure to follow the on-screen software instructions
Switch the ignition OFF at this step. Click “OK”
The procedure was successful and the new ECU has been initialised.
The car is starting and functioning as expected.
Mention that the car must have a minimum set of two programmed keys as a prerequisite so that the Initialisation can begin.
#UsingModule #InitilisationafterECU #RangeRover2017
Thank For 
Jaguar Land Rover Coding and Configuration
68 D. No. 60, An Phu, District 2, Ho Chi Minh City 
