A Toyota Reiz 2010 replace steering wheel,it need perform electronic power steering system programming.So here show you the test on how to use Launch X431 Pro to perform Toyota Reiz 2010 electronic power steering system programming.And more posts about Toyota,please check this collection:Toyota trouble repair
What You Need?
1.Switch on the ignition.
2.Select the Toyota Version above V48.31.
3.Select 16PIN Diagnostic Socket.
5.Select”w/AFS OFF Switch”
6.Select “System Selection”
9.Select “Read Fault Code”
10.Select special function.
11.Select torque sensor calibration.
12.Pay attention to the prompt
13.Pay attention to the prompt
14.Ensure the vehicle is stationary, the ignition is on, then click confirm button.
15.Confirm the PS (power steering) warning lamp is on. After confirmation, it prompts counting down 40 seconds “Calibrating, the remaining time is ** seconds”.
16.Pay attention to the prompt, see Picture 5, “Ensure the steering wheel is at the center. Note, during the operation of next step, the steering wheel will swing. Do not touch it!” Click CONFIRM button.
17.When the steering wheel stops swinging, click confirm, it prompts “Calibrating, the remaining time is ** seconds”.
18.It prompts “Torque sensor calibration completed”, indicating the sensor learning succeeded.
19.Click confirm, exit from the software. Turn off the ignition.
More test report about Launch X431 please check:Launch X431 Test report
#odisengineeringdownload #odisengineeringlongcoding #odisengineeringlogincode #odisengineeringadaptation #volkswagenimmobilizerdelete #volkswagenimmobilizerbypass #audiecuimmobilizerremoval #audiimmobilizerprogramming #audiretrofitambientlighting #audiretrofitandroidauto #audiretrofitapplecarplay #fordf150retrofitheadlights #fordfiestaretrofitheadlights #fordfiestaretrofitcruisecontrol #fordretrofitelectric #fordincodecalculator #fordbcmincode #howtogetfordincode #fordidslogin #fordidssupport #fdrsforddiagnostic