| Subtotal | $0.00 |
|---|---|
| Total | $0.00 |
This instruction show you guide on how to use VCDS to calibrate dashboard needle sweep staging.For more VCDS projects,please check here:VCDS Test Feedback.
Steps:
Connect VCDS cable to your vehicle,then run software and click “Select Control Module”
Select “17-Instruments”
Select “Adaptation-10”
Scroll down and search for “ IDE01087-Staging”
Find “New Value” and hit it, select “Active”
Select “Do It” and “Yes”
It shows controller accepted the request, will now read the channel again…. Hit “OK”
Hit “Go Back” , Now calibration is done.
If you want to know more about Seat Neon, please refer to Seat trouble repair.
#NeedleSweepstagingcalibration #VCDS #SeatLeon
Thank For 
Lamboghini Service Component Protection, Immobilized , SVM
Immobilizer Service Remove VAG Group
Software Version Management (SVM) VAG Group
BENTLEY Service Component Protection, Immobilized , SVM
68 D. No. 60, An Phu, District 2, Ho Chi Minh City 
